Body and Framework

This week we need to start focusing on the frame of SK2 because if not were going to be held up in the future. So we are going to remove the lone supporting bar on the left of the drivers seat that is no use to the car or driver. Furthermore we must refine the supports around and behind the driver while adding in 2 battery mounting brackets behind the driver. to do this we will be using long aluminum 1/4" bars and cutting them into defined pieces for the bracket. The weeks goals include . . .

a) putting on the tie bars

b) putting on the seat

c) building the mounting brackets

Jaret tests out the seat on SK2

Jack is sawing leftover aluminum for the mounting brackets